Hi, I'm not aware of this kind of software, there is some online templates that will give you information the same that you would find in design handbooks (I prefer the latter). I would recommend to build your own books and source database and then to have a work spreadsheat with comments on each design step (range, values, settings, etc.). On the hydraulics side, you can work with software like OpenFoam for 3D simulation or IBER for 2D, both are simple to use and you will able to check flow patterns and mixing compliance on process like coagulation or flocculation (filtration is quite hard to simulate). For equipment selection you will find on-line tools for pumps and other equipment sizing made by suppliers (i.e. Grundfos). I hope it could help, bye.

Published by

Hi, I'm not aware of this kind of software, there is some online templates that will give you information the same that you would find in design handbooks (I prefer the latter).

I would recommend to build your own books and source database and then to have a work spreadsheat with comments on each design step (range, values, settings, etc.).

On the hydraulics side, you can work with software like OpenFoam for 3D simulation or IBER for 2D, both are simple to use and you will able to check flow patterns and mixing compliance on process like coagulation or flocculation (filtration is quite hard to simulate).

For equipment selection you will find on-line tools for pumps and other equipment sizing made by suppliers (i.e. Grundfos).

I hope it could help, bye.